Campbell-scientific AVW200-series Vibrating Wire Interfaces Bedienungsanleitung PDF herunterladen (Seite 37)

AVW200-series 2-Channel Vibrating Wire Spectrum Analyzer Modules

5.2.2 Measurement

The Deployment/Measurement Tab is used to configure the SDI-12 Address,

multiplexer type, begin frequency, end frequency, and excitation (see FIGURE

5-3).

FIGURE 5-3. Deployment/Measurement Tab in DevConfig

The Begin Frequency, End Frequency, and excitation parameters

in DevConfig are only used for the RS-232 (terminal commands)

and SDI-12 communication modes. When using the RS-232

(PakBus) or RF (PakBus) communication modes, the settings for

the Begin Frequency, End Frequency, and excitation parameters

are entered in the AVW200() CRBasic instruction (see Section

Programming).

Description of the Measurement Settings follows:

SDI-12 Address—select an address if using SDI-12. Otherwise use the default

value of 0.

NOTE

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 111 112

Keine Kommentare

Campbell-scientific AVW200-series Vibrating Wire Interfaces Bedienungsanleitung Seite 37