Campbell-scientific UT20 and UT30 Tower-based Weather Stations Bedienungsanleitung PDF herunterladen (Seite 34)

UT20 and UT30 Tower-based Weather Stations

FIGURE 8-4. BPALK 12 volt power supply

8.1.5 SP10 Solar Panel

Solar panels purchased from Campbell Scientific are shipped with a charge

plug taped to the back of the panel. The charge plug is not used with the

PS100. Refer to the solar panel manual for installation instructions.

1. Mount the SP10 solar panel to the mast, facing south (northern

hemisphere) as shown in FIGURE 8-6. Position the SP10 at the top of the

1 1/4 inch diameter section of the mast. Install the U-bolt, muffler clamp,

and nuts as shown in FIGURE 8-6.

2. The solar panel should be oriented to receive maximum insolation over the

course of the year. Suggested tilt angles (referenced to the horizontal

plane) are listed below.

Site Latitude Tilt Angle

0 to 10 degrees 10 degrees

11 to 20 Latitude + 5 degrees

21 to 45 Latitude + 10 degrees

46 to 65 Latitude + 15 degrees

> 65 80 degrees

3. After determining the tilt angle, loosen the two bolts that attach the

mounting bracket to the panel. Adjust the angle, then tighten the bolts.

Secure the lead wire to the mast using wire ties.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 73 74

Keine Kommentare

Campbell-scientific UT20 and UT30 Tower-based Weather Stations Bedienungsanleitung Seite 34