Campbell-scientific CR9000X Measurement and Control System Bedienungsanleitung PDF herunterladen (Seite 17)

Quick Start

QS1.6 Setting Up IP Communications

Once serial communications has been established, the CR9000X's IP can be

set. First you have to be connected to the CR9000X through the RS232

port. Next go into RTDAQ's Terminal Mode window

(Datalogger/Terminal Emulator). Click on "Open Terminal" in the "I/O

Port" section and then press <enter> recursively until the "CR9000X"

prompt appears. Press C and <enter>. If you delay for too long, you may

need to press <enter> to re-invoke the CR9000X prompt. The CR9000X's

IP port settings will be shown. To change any of the settings, type in the

associated number, enter the new setting and press <enter>. Once

complete, type in 6 (Save and Exit). Press <enter> until you get the

CR9000X prompt and type in C and <enter> to verify new settings.

For communications across a LAN, or through the Internet, a straight CAT

5 Ethernet cable should be used. For hooking up directly to your PC's

Ethernet port, a CAT 5 Ethernet crossover cable is required.

After the CR9000X's IP settings have been set, you will need to add another

logger communication station, this time setting it up for IP communications

instead of serial communications. Before RTDAQ will allow you to set up

another station, it will be necessary to "Disconnect" from the Serial

Connected Logger (station that we just created). To start, press the Icon

with a data logger + sign to start the Station set-up wizard again. This time

select "IP Port" for the Communication Mode. Once you have setup the IP

station, if communication is still not established, read the section QS1.6.1,

"IP Port Set-up Tips".

To change a setting, type in the associated number and

press <enter>.

First, click on "Open Terminal". Next press <enter>

until the CR9000X prompt is returned. Type in "C"

and <enter> and the CR9000X's I/P port setting will

e returned.

In this example, a 3 (IP Address) was typed in. The

CR9000X responded with the its current IP address and the

software is waiting for a new IP address to be entered.

After changes are made and entered, enter 6 and hit

<enter> to "Save" the new values to the logger.

QS-9

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 441 442

Keine Kommentare

Campbell-scientific CR9000X Measurement and Control System Bedienungsanleitung Seite 17