Campbell-scientific LP02 Hukseflux Pyranometer Bedienungsanleitung PDF herunterladen (Seite 16)

LP02 Pyranometer

7. Operation

7.1 Wiring

A schematic diagram of the LP02 is shown in FIGURE 7-1.

White

Green

Clear

FIGURE 7-1. LP02 Schematic

When Short Cut is used to create the datalogger program, the sensor should be

wired to the channels shown in the wiring diagram created by Short Cut.

A differential voltage measurement is recommended because it has better noise

rejection than a single-ended measurement. If a differential channel is not

available, a single-ended measurement can be used.

Connections to Campbell Scientific dataloggers for a differential measurement

are given in TABLE 7-1. A user-supplied jumper wire should be connected

between the low side of the differential input and ground (AG or

) to keep

the signal in common mode range.

Connections to Campbell Scientific dataloggers for a single-ended

measurement are given in TABLE 7-2.

TABLE 7-1. Differential Connections to Campbell Scientific Dataloggers

Color

Description

CR9000(X)

CR5000

CR3000

CR1000

CR800

CR850

CR510

CR500

CR10(X)

21X

CR7

CR23X

White Signal (+) DIFF Analog High DIFF Analog High DIFF Analog High

Green Signal (–) *DIFF Analog Low *DIFF Analog Low *DIFF Analog Low

Clear Shield

* Jumper to AG or

with user supplied wire.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Keine Kommentare

Campbell-scientific LP02 Hukseflux Pyranometer Bedienungsanleitung Seite 16