Campbell-scientific DCP100 GOES Data Collection Platform Bedienungsanleitung PDF herunterladen (Seite 19)

DCP100 DATA COLLECTION PLATFORM

11

9.1.2 Datalogger Programming Theory

Campbell Scientific dataloggers are

programmed via a keyboard/display or an IBM-

PC compatible computer running PC208

software. Please see the appropriate

datalogger manual for detailed programming

information.

To transmit two different arrays the datalogger's

program must have this structure:

Set Output Flag 0 high (10) based on condition 1

Output Processing Instructions

Conditional Statement; if true “Then Do”

(Command Code 30)

P120 Data transfer to TGT1

Set Output Flag 0 high (10) based on

condition 2

Output Processing Instructions

Conditional Statement; if true “Then Do”

(Command Code 30)

P120 Data Transfer to TGT1

Table 9.1-2 illustrates the correct programming

structure.

TABLE 9.1-2 CR10X Example Program

This example makes a thermocouple and

battery voltage measurement and sends data to

the TGT1's buffer only when the CR10X

generates an output.

NOTE: Use a conditional statement (i.e.,

Instruction 92) to transfer data only when

there is an output to final storage.

;

*Table 1 Program

01: 10.0 Execution Interval

(seconds)

;Measure reference temperature.

01: Internal Temperature (P17)

1: 1 Loc [ RefTemp ]

;Measure thermocouple temperature.

02: Thermocouple Temp (DIFF) (P14)

1: 1 Reps

2: 1 ± 2.5 mV Slow Range

3: 5 DIFF Channel

4: 1 Type T (Copper-Constantan)

5: 1 Ref Temp Loc [ RefTemp ]

6: 2 Loc [ TCDeg_C ]

7: 1 Mult

8: 0 Offset

;Measure battery voltage every 10 seconds.

03: Batt Voltage (P10)

1: 3 Loc [ Battery ]

;Set Output Flag High (10) for hourly data (user

defined).

04: If time is (P92)

1: 0 Minutes (Seconds --) into a

2: 60 Interval (same units as above)

3: 10 Set Output Flag High

;Timestamp data

05: Real Time (P77)

1: 220 Day,Hour/Minute (prev day

at midnight, 2400 at

midnight)

;Output hourly the average reference Temp, TC

Temp, and battery voltage.

06: Average (P71)

1: 3 Reps

2: 1 Loc [ RefTemp ]

;Sample the forward and reflected power.

07: Sample (P70)

1: 2 Reps

2: 4 Loc [ FwdPwr ]

;Transfer data to TGT1 every hour.

08: If time is (P92)

1: 0 Minutes (Seconds --) into a

2: 60 Interval (same units as

above)

3: 30 Then Do

;Transfer datalogger's final storage data to the

TGT1, read the transmitter's latest forward and

reflected power readings, and place the results

in two sequential input locations.

09: Data Transfer to GOES (P120)

1: 00 Buffer Selection

2: 4 FWD/Ref Power Loc

[ FwdPwr ]

10: End (P95)

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare